Easy Immobilizer Option For Kia And Others

Easy Immobilizer Option For Kia And Others

If your looking for an easy answer to your car getting stolen, we have one for you. It’s a wireless activated relay that replaces your fuel pump relay. It comes with 2 wireless controllers that use a CR2022 lithium battery. We will get into the details below but if you want to bypass them, here’s a link where you can purchase now. 

We purchased and reviewed these and there are some things you should know about how they operate. We don’t think the instructions they come with are clear.,

The instructions provided start at step 4 and then say at step 6 after installation “When the flame is off, close the window door engine cover and then lock the door”.  We have no clue what they are talking about.  I actually feel bad as the product actually works, but the ads are just painful.

The good news is that despite the ad, the product works and the written instructions it comes with are better.  It is not really that hard to figure out. There are different modes depending upon how you wish to use it, we picked the full on mode all the time, knowing this would deplete the battery and it lasted over 2 month. Pretty impressive just using CR2032 batteries. You can also set to manual mode where by you have to hit the remote prior to starting the engine. There is also a 3rd mode called Anti-Hijacking mode where the engine will start but must receive a signal within 1 minute  or else it will turn off.  If a low battery, a light on the remote will flash red every 3 seconds to let you know to replace.  

Product description
A.begin the engine for the first time: the unit begin scanning the sensor ID password, which matches within 25 seconds, The car can be driven off successfully. If not successful, the fuel circuit will be cut off after 25 seconds, and the engine will stop.

B.begin the engine for the 2nd time: the unit shortens the scanning time to 20 seconds.

C.begin the engine for the 3rd time: the unit shortens the scanning time to 10 seconds.

D.begin the engine for the 4th time: Unit can not scan correct password that it was started illegally.No matter how many times it is started, the unit can sense the correct password before driving the car.

E.In the hidden-lock mode, the driving no longer scans the sensor ID,and the sensor needs to be sensed again after turning off.

F.In the anti-hijacking mode, the unit will begin normally after receiving the correct signal after starting the engine. If it does not receive the correct signal from the remote control within 1 minute, it will turn off. Receive signals while driving.

So if your looking for an easy to install and setup answer this is it.